User's Manual

8
2. HARDWARE INSTALLATION
2.1 Front panel
EPS11 has 3 LED indicators on its front panel. Refer to the following
table for the meaning of each indicator.
LEDs Description.
Power Power status indicator. A steady light indicates
power is being applied to the EPS11 unit.
Traffic Data traffic indicator. A blinking light indicates that
at least one person is doing a presentation via
EPS11 on the projector.
Link
Status
Wireless link status indicator. A steady light
indicates the EPS11 unit is connected to an AP or
Ad-Hoc client through a wireless network.
2.2 Rear Panel
The rear panel features a n AC power inlet socket, a VGA port, and a
Factory Reset button. Refer to the table below for the description of each
item.
Power The power inlet socket of the EPS11. Please
make sure that you use the right power adaptor to
avoid damaging this unit.
VGA
port
The VGA output of the EPS11. It is used to
connect to the projector’s VGA port with a VGA
cable.
Reset
button
Pressing this button for 5 seconds resets the
configuration to the default setting.
2.3 Network Setup
You can easily connect to EPS11 with the EPS11’ s client utility