User's Manual

16
4.2 Running the EPS player
(i) Double -click the icon on the desktop to run the “EPS player”
program.
(ii) On the Welcome ! window, check the Only use Ad-Hoc mode
checkbox to make EPS player connect to the EPS unit in Ad-Hoc mode.
Uncheck this box to keep the player’s original setting.
When done, click the Next button to proceed.
(iii) The EPS player is now searching for every EPS unit on the network.
The search may take several seconds. If at least one EPS is found, the
Presentation Station Found window (Graph 1) is displayed. Proceed to
step (iv) continue the setup.
If no EPS is found, the Presentation Station Couldn’t be found window
is shown (Graph 2). You can click the Search Again button to searching
over or click the Exit button to end the player program.