User Manual

14. After setting the Resource and Properties fields, Windows NT will begin
installing the network components you’ve selected. You may be presented
with the screen shown in Figure 6-14, asking if you would like to configure
the protocols with a DHCP server on your network. Click the Yes or No
button to continue. This setting may also be changed at a later time.
15. In the event that the screen shown in Figure 6-15 appears, do not make any
changes unless you are proficient with the advanced networking properties
of Windows NT. Click the Next button to continue.
16. At this point, Windows NT will let you know that it is ready to start the net-
work. If you’d like to stop the procedure, click the Back button. To contin-
ue, click the Next button.
Figure 6-14
Figure 6-15
12. Windows NT may
request further
files at this point
(as shown in
Figure 6-12). Type
“ D:\WINNT”
(where “D” repre-
sents your CD-
ROM drive) in the
field provided and
click the Continue
button.
If files are still requested, insert your Windows NT CD into your CD-ROM
drive and type “D:\i386” (where “D” represents your CD-ROM drive).
Then, click the Continue button.
13. You will now reach the screen shown in Figure 6-13. This is called the
Resources & Properties screen. It is recommended that you leave these
options at their
default settings. If
settings must be
changed, it is pre-
ferred that you use
the Configuration
Utility that came
with the Network
PC Card. If you
must adjust the set-
tings on this screen,
refer to Chapter 9:
Advanced
Properties for more
information on the
Advanced
Properties for
Windows NT. Click
the OK button to
continue.
Network PC Card
Figure 6-12
Figure 6-13
Instant Wireless
Series
23 24