User Manual

—Using the Wireless Utility
25
Using the Wireless Utility
The following example will help you set up a peer-to-peer connection with the Wireless LAN card.
Note!
For information on connecting your wireless LAN card
to the LAN, contact your system administrator.
1. Insert a Wireless LAN card into the PCMCIA slots of two Notebook PCs.
2. Install the card drivers on both notebook computers (refer to Chapter 3).
3. Install the software on both notebook computers (refer to page ! ).
4. After you have installed the software and rebooted, double-click the icon
in the lower corner of your
screen to open the configuration utility:
5. Click the Configuration tab:
6. Select 802.11 AdHoc from the Mode dropdown list. The SSID should be the same as the one that you
entered when installing the software. Leave the other settings at their default values.
7. Perform steps 1 through 3 on another notebook PC. When the two computers have connected via the Wireless
LAN cards, the tray icon turns green
and the Link Info tab of the configuration utility shows an active
connection: