User's Manual Part 2

3. Highlight Protocol from the
list of network component
types, as shown in Figure 8-3,
and click the Add button.
4. From the screen
shown in Figure 8-
4, select Microsoft
from the list of
“Manufacturers”
and TCP/IP from
the list of “Network
Protocols” and click
the OK button.
Repeat steps two
through four to
install other proto-
cols, such as
NetBEUI or IPX/SPX.
5. To verify that the drivers are
working under Enhanced
Mode on the Driver Type tab
or reconfigure the card on
the Advanced tab, go to the
screen shown in Figure 8-2
and click the Properties but-
ton. This will bring up the
Properties Tabs, where such
values can be refined.
When finished, you must
restart your computer to
complete installation.
40
Chapter 8: Installing Netw ork
Protocols
Protocols are necessary for computers to communicate on your network.
1. From the Start
Menu, select
Settings and
bring up the
Control Panel,
as shown in
Figure 8-1. From
the Control
Panel, double-
click the
Network icon.
2. Select Instant Wireless
Network PC Card V3.0
from the list (as shown in
Figure 8-2) and click the
Add button.
39
Figure 8-3
Figure 8-4
Figure 8-5
Netw ork PC Card
Figure 8-1
Figure 8-2
Instant Wireless
Series