User's Manual

• Using Remote Upgrade

This feature allows you to upgrade the Router’s firmware from a remote

location. To enable Remote Upgrade, click on Enable, and then click the

Apply button. Remote Management must be activated before you can man-

age the Router from a remote location.

• Using MTU (Maximum Transmission Unit)

This feature specifies the largest packet size permitted for network trans-

mission. Select Enable and enter the value desired. It is recommended that

you leave this value in the 1200 to 1500 range. For most DSL users, it is

recommended to use the value 1492. By default, MTU is set at 1500 when

disabled.

IImmppoorrttaanntt::

Upgrading may cause the

Router to be reset to the factory

defaults. Make a record of all set-

tings before attempting the upgrade.

Wireless Access Point Router with 4-Port Switch

BEFW11S4 VER 3 USER GUIDE_2nd.qxd 10/15/02 10:35 AM Page 39