Apollo 2 Driver Installation Manual AFRAID-081699 ITeX™ Apollo 2 ADS Network Modem Installation Manual For Windows® 95, 98, and NT4.0 August 16, 1999 Integrated Telecommute Express, Inc.
Apollo 2 Driver Installation Manual AFRAID-081699 TeX Table of Contents ABOUT T His GUIDE 1. INTRODUCTION SYSTEM REQUIREMENT. Hardware Requirement Software Requirement.. 2, INSTALLING THE ADS NETWORK MODEM BOARD 3. INSTALLING THE APOLLO 2 DEVICE DRIVERS AND 3.1 WINDOWS 9 3.2 WINDOWS 95 3.3 Winnows NT4.0 WITH SERVICE PACK 3 3.4 INSTALLING THE APOLLO 2 MOD! 4. VERIFYING THE DRIVER INSTALLATION... 4.1 WINDOWS 95 AND WINDOWS 98 4.2 WINDOWS NT 4.0 5. CONFIGURING THE ADS NETWORK FOR ETHERNET OVER ATM (RFC1483) 6.
Apollo 2 Driver Installation Manual AFRAID-081698 1. INTRODUCTION The Apollo 2 ADS Network Modem is an internal ADS modem, which conveniently plugs into a PC system, eliminating the need for an external modem. The Apollo 2 ADS. Network Modem connects to a telephone line via a standard JR-11 connector and fully complies with practices governing the PC world (e.g. Plug 'n Play).
Polio 2 Driver Installation Manual AFRAID-081699 System Requirement The following equipment and information is required (at a minimum) to setup your ADS network modem. Hardware Requirement The following is the minimum hardware requirement. Please make sure your PC system meets ALL of the following requirements.
Apollo 2 Driver Installation Manual AFRAID-081699 TeX" Before you start: [TeX ADS Network Modem Installation: and Configuration Flow Chart Step 8 Activating the Polio 2 ADS Network Modern (Step 1) insert : (Step 2) Cores ADS Network | ad NMC to ADS MMC) Hearken I (stop 9) Moratorium the (Step 3) Installing Allie 2 ADS Device Driver ard Network Modem quirky Program ; «I EEN Sel Integrated Telecommute Express, Inc.
Apollo 2 Driver Installation Manual AFRAID-081699 2. INSTALLING THE ADS NETWORK MODEM BOARD To install the Apollo 2 ADS Network Modem in your PC and connect it to ADS network, follow these steps: insert ADS Network Interface Card — Step 1 1) Open the shipping container and inspect each item for damage. 2) Remove all jewelry from your hands and wrists. Use ‘only insulated or nonproductive tools, 3) Unplug the PC and disconnect all cables. 4) Remove the PC cover. 5) Choose an empty bus mastering PCI slot.
Apollo 2 Driver Installation Manual AFRAID-081699 3. INSTALLING THE APOLLO 2 DEVICE DRIVERS AND UTILITY Please have the following information available in order to complete the installation and setup of the TeX Apollo 2 ADS Network Modem. 1. TCP/IP properties, this includes the PVC values (VP and VOUCH, IP address, the gateway, and the domain name server. You will need this information fo complete the configuration of the network modem card.
Apollo 2 Driver installation Manual AFRAID-081698 The Add New Hardware Wizard window will appear. When prompted, select "Search for the best driver for your device. (Recommended)". Click "Next". If your Apollo 2 ADS Newark Modem comes with floppy diskettes, then insert the Windows 98 driver diskette (use the Windows 98 2 edition diskette for installing an Windows 98 2™ edition and the Windows 98 diskette for installing on Windows 98 1 edition) into the floppy disk drive.
Apollo 2 Driver Installation Manual AFRAID-081699 Windows should find the *.INF (NETIQUETTE for Windows 98 2™ edition) file in the directory specified. Click “Next” to continue. Windows will start to copy the drivers. Make sure that the Windows the CD-ROM or that it is easily accessible, Integrated Telecommute Express, Inc.
Apollo 2 Driver installation Manual AFRAID-081699 SUR . 0s oe For RFC1483, the default PVC values are 8 and 35 for VP| and VC respectively. If necessary, these values can be changed at this time. The range for both VPI and VCI is from 0 to 255. Windows has finished installing all the TeX ADS Network Modem drivers. Click "Finish" to complete the installation.
Apollo 2 Driver Installation Manual A2RAI-0816%9 3.2 Windows 95 * BEFORE YOU START: You need the Windows 95 system installation files to complete the installation. This section describes how to install the network driver when your PC is running Windows 95.
Apollo 2 Driver Installation Manual AFRAID-081699 For RFC 1483, the default PVC values are VPI=8 and VCI=35 respectively. If necessary, these values can be changed at this time. The range for both VP! and VCl is 0 to 255. For more detailed information regarding the values of VPI and VCI, please check with your ADS service provider. CAUTION: Failure to setup the right VPI, VCI may cause the ADS. network fo fail. Follow the screen instructions until Windows 95 asks you to restart your computer.
Apollo 2 Driver Installation Manual AFRAID-081699 Windows 95 + It Ex ADS Network Modem (Apollo 2 mitosis) = ATM Cali Manager -> It Ex ADS Network Modern (Apollo 2 8MB/s) = TCP/IP Click "Cancel" to close the Network window. 4.2 Windows NT 4.0 Double-click the Network icon. The network dialog window appears. [n the Network dialog window, select the Configuration tab.
Polo 2 Driver Installation Manual AFRAID-081698 FEY SWAZILAND > Microsoft PRE over ATH Adapter FR TOP RP > ATH Emulated LAN TCPVIP > Diatribe Adapter § 4 i VAM toupee For ATi Clint for Microsoft N Select the Configuration Tab and scroll! through the installed network component list. For Windows 98 2" Edition, highlight the TCP/IP > [TeX RFC1483 Theme Adapter component. For Windows 98 1= Edition, highlight the ADS Network Modem (Apollo 2 8Mbps). For Windows 95, highlight "TCPAP". Click "Properties.
Apollo 2 Driver Installation Manual AFRAID-031699 To setup a new gateway, enter the setting in the new gateway section and click "Add." This will add the setting into the installed gateways. To configure the Domain Name Server, simply select the Enable DNS option. Enter the Host and Domain settings. Enter the DNS Server search order and click "Add." Once all the TCP/IP properties have been set, click “OK” to rectum to the Network window. Integrated Telecommute Express, Inc.
Apollo 2 Driver Installation Manual AFRAID-081699 To SEs gs = B— Tempe Are) Ta AT EA Coll Mb megastars <> 37 ad ACYL Satori Modem [hoof Click "OK" ta close the Network window, § 3 gq Click "No" when prompted "Do you want to restart your computer now?" SETTING THE PVC VALUES FOR ETHERNET OVER ATM (RFC1483) Windows 98 2" Edition For RFC1483, the VPI and VCI have a default setting of 8 and 35 respectively, To change the values for RFC1483, folio these instructions: Using the Modem lean Utility to Sst the PVC V
Apollo 2 Driver Installation Manual AFRAID-081699 5.2 Windows NT4.0 Ethernet over ATM (RFC1483) Open the Network dialog window by double clicking My In the Network window, select the Adapters tab. Se roll through the installed network components fist. Highlight the "TeX ADS Network Modem (Apollo 2 8Mbps)” and click Proprieties. The TCP/IP Properties window appears, Please check your TCP/IP configuration with your Internet service provider. After setting up the TCP/IP configuration. Restart your computer. 6.
Apollo 2 Driver Installation Manual AFRAID-081699 i hee RE WE TOE ARs = Narnia mnt & Hark sh t 001 DOR 75% F thee TOE relates Land a EE Gat i Scanter : TEP o> IT aC FIFE 1400 I therms decimate: 2 mtn Eire te Eloy pears From the Network configuration window, select the "TCP/IP > [TeX ADS Network Modem {Apollo 2 8 Mb/s)" option in the configuration tab, click “Properties.” The TCP/IP Properties window will appear. 5 . i 192 . 1668. a4 .
Apollo 2 Driver Installation Manual AZRAI081699 setup a new gateway, enter the setting in the new gateway section and click "Add." This will add the setting into the installed gateways. f win SAE Son configure the Domain Name Server, simply select the Enable DNS option, Enter the Host and Domain settings. Enter the DNS Server Search Order and click “Add.” Once all the TCP/IP properties have been set, click “OK” to rectum to the Network window. Integrated Telecommute Express, Tne.
Apollo 2 Driver Installation Manual AFRAID-081699 Text ADS Network Modern (Apollo 2 BM b/s] MR Micros of PRE over AT i Adapter STM Call Manege > IT
Apollo 2 Driver Installation Manual AFRAID-081699 SWAZILAND -> Microsoft PPP over ATM Adapter WAN support for ATM -> {TeX AZ ADS NIC Microsoft PPP over ATM Adapter Click "OK," Windows may ask to insert the Windows 98 CD. Make sure that the Windows the CD-ROM, click "OK." Restart the computer. 7.2 ESTABLISHING A PPP OVER ATM CONNECTION From the Start menu, select Programs, select Accessories, select Communications, and then double click on Dial-Up Networking. Double dick on the "Make New Connection” Icon.
Apollo 2 Driver Installation Manual AFRAID-081699 10. UNINSTALLING THE APOLLO 2 ADS NETWORK MODEM AND TEST APPLICATION To uninstall the software drivers: * Right click on the "My Computer” icon; select Properties; select Device Manager; Scroll down to "Network Adapters.” Open the “Network Adapters” folder. + Right click “[TeX AZ ADS NIC" and click "Remove. Click "OK" when prompted with a warning about removing and adapter. Click "OK” to close the Systems window.
2. Connector Pin out The Polio 2 ADS NIC card has a dual JR-11 connector, The top frack Is for the ADS phone line. The bottom jack can be used to connect a phone or an analog modem. The table below describes the connector pin out for both jacks.
