User Manual
Table Of Contents
- Table of Contents
- List of Figures
- 1. EDB9307A Kit Contents
- 2. Introducing the EDB9307A Engineering Development Board
- 3. Getting Started
- 4. EDB9307A Circuit Description
- 5. Software
- 6. Developer’s User Forum
- 7. Other Useful Information
- Appendix A. Schematics
- Appendix B. Programming Linux Images into Flash from a Windows® PC
- Revision History
EDB9307A
Technical Reference Manual
DS667DB1 ©Copyright 2006 Cirrus Logic, Inc. 33
Downloading Files
1. Make a directory called "TFTPROOT" on C:\
2. Use a computer that has an Internet connection and download the files specified in "D. Software"
to the directory made in step 1.
3. Disconnect the Ethernet cable if using Wired Ethernet. Plug in the Ethernet cross-over cable into
the computer's Ethernet port.
Windows PC Ethernet Setup
1. Go to Control Panel, click on Network Connections. Click on the Ethernet port icon representing
the RJ45 port on the computer. In the scroll box, go to the end and double click on the item called
Internet Protocol (TCP/IP).
2. Under the General tab, enable Use the following IP address and configure per the picture below.
When done, click on OK and then OK again for changes to take effect.
Note: The IP address can be any address you chose, just make sure it matches the IP address you use in the fconfig step below.