Manual

CS8952
CrystalLAN™ 100BASE-X and 10BASE-T Transceiver 34
DS206F1
3 Auto-Neg Ability Read Only 1 This bit indicates that the CS8952 has auto-negotia-
tion capability. Therefore this bit will always read
back a value of 1.
2 Link Status Read Only 0 When set, this bit indicates that a valid link has been
established. Upon a link failure, this bit is cleared and
latched. It will remain cleared until this register is
read.
1 Jabber Detect Read Only 0 In 10BASE-T mode, if the last transmission is longer
than 105 ms, then the packet output is terminated by
the jabber logic and this bit is set. If JabberiE (Inter-
rupt Mask Register (address 10h), bit 3) is set, an MII
Interrupt will be generated.
This bit is implemented with a latching function so
that the occurrence of a jabber condition causes it to
become set until it is cleared by a read to this regis-
ter, a read to the Interrupt Status Register (address
11h), or a reset.
No jabber detect function has been defined for
100BASE-TX.
0 Extended Capability Read Only 1 This bit indicates that an extended register set may
be accessed (registers beyond address 01h). This bit
always reads back a value of 1.
BIT NAME TYPE RESET DESCRIPTION