Owner manual

CS5566
6 DS806PP2
5/4/09
SWITCHING CHARACTERISTICS
T
A
= -40 to +85 °C; V1+ = V2+ = +2.5 V, ±5%; V1- = V2- = -2.5 V, ±5%;
VL - VLR = 3.3 V, ±5%, 2.5 V, ±5%, or 1.8 V, ±5%
Input levels: Logic 0 = 0V Low; Logic 1 = VD+ = High; CL = 15 pF.
8. BP/UP can be changed coincident CONV falling. BP/UP must remain stable until RDY falls.
9. If CONV
is held low continuously, conversions occur every 1600 MCLK cycles.
If RDY is tied to CONV, conversions will occur every 1602 MCLKs.
If CONV is operated asynchronously to MCLK, a conversion may take up to 1604 MCLKs.
RDY falls at the end of conversion.
10. RDY
will fall when the device is fully operational when coming out of sleep mode.
Figure 1. Converter Status (Not to scale)
Parameter Symbol Min Typ Max Unit
Master Clock Frequency Internal Oscillator
External Clock
XIN
f
clk
6
0.5
7
8
8
8.1
MHz
MHz
Master Clock Duty Cycle 40 - 60 %
Reset
RST
Low Time t
res
1--µs
RST
rising to RDY falling Internal Oscillator
External Clock
t
wup
-
-
240
3084
-
-
µs
MCLKs
Conversion
CONV
Pulse Width t
cpw
4--MCLKs
BP/UP
setup to CONV falling (Note 8) t
scn
0--ns
CONV
low to start of conversion t
scn
- 1182 1186 MCLKs
Perform Single Conversion (CONV
high before RDY falling) t
bus
20 - - MCLKs
Conversion Time (Note 9)
Start of Conversion to RDY
falling t
buh
- - 1604 MCLKs
Sleep Mode
SLEEP
low to low-power state
SLEEP
high to device active (Note 10)
t
con
t
con
-
-
50
3083
-
-
µs
MCLKs
1182 - 1186 MCLKs
Converter
Status
CONVERT
RDY
IDLEIDLE CONVERT
SDO
ACTIVE
t
bus
354 + 64 MCLKs
1600 - 1604 MCLKs