Manual

CS5490
40 DS982F3
6.6.13 Interrupt Mask (Mask) – Page 0, Address 3
Default = 0x00 0000
The Mask register is used to control the activation of the INT
pin. Writing a '1' to a Mask register bit will allow
the corresponding Status0 register bit to activate the INT
pin when set.
[23:0] Enable/disable (mask) interrupts.
0 = Interrupt disabled (Default)
1 = Interrupt enabled
6.6.14 Chip Status 1 (Status1) – Page 0, Address 24
Default = 0x00 0000
This register indicates a variety of conditions within the chip.
[23:16] Reserved.
LCOM[15:8] Indicates the value of the last serial command executed.
[7:4] Reserved.
TOD Modulator oscillation has been detected in the temperature ADC.
VOD Modulator oscillation has been detected in the voltage ADC.
[1] Reserved.
IOD Modulator oscillation has been detected in the current ADC.
23 22 21 20 19 18 17 16
DRDY CRDY WOF - - MIPS 0 VSWELL
15 14 13 12 11 10 9 8
0 POR 0 IOR 0 VOR 0 IOC
76543 2 10
0 VSAG TUP FUP IC RX_CSUM_ERR -
RX_TO
23 22 21 20 19 18 17 16
------
15 14 13 12 11 10 9 8
LCOM[7] LCOM[6] LCOM[5] LCOM[4] LCOM[3] LCOM[2] LCOM[1] LCOM[0]
76543210
----TODVOD-IOD