Owner manual

CS5484
DS981F3 45
6.6.13 Interrupt Mask (Mask) – Page 0, Address 3
Default = 0x00 0000
The Mask register is used to control the activation of the INT
pin. Writing a '1' to a Mask register bit will allow
the corresponding Status0 register bit to activate the INT
pin when set.
[23:0] Enable/disable (mask) interrupts.
0 = Interrupt disabled (Default)
1 = Interrupt enabled
6.6.14 Chip Status 1 (Status1) – Page 0, Address 24
Default = 0x80 1800
This register indicates a variety of conditions within the chip.
[23:16] Reserved.
LCOM[7:0] Indicates the value of the last serial command executed.
V2OD (V1OD) Modulator oscillation has been detected in the voltage2 (voltage1) ADC.
I2OD (I1OD) Modulator oscillation has been detected in the current2 (current1) ADC.
23 22 21 20 19 18 17 16
DRDY CRDY WOF - - MIPS V2SWELL V1SWELL
15 14 13 12 11 10 9 8
P2OR P1OR I2OR I1OR V2OR V1OR I2OC I1OC
76543 2 10
V2SAG V1SAG TUP FUP IC RX_CSUM_ERR -
RX_TO
23 22 21 20 19 18 17 16
--------
15 14 13 12 11 10 9 8
LCOM[7] LCOM[6] LCOM[5] LCOM[4] LCOM[3] LCOM[2] LCOM[1] LCOM[0]
76543210
- - - - V2OD V1OD I2OD I1OD