User Manual
CS5463
8 DS678F3
ANALOG CHARACTERISTICS (Continued)
Notes: 3. Applies before system calibration.
4. All outputs unloaded. All inputs CMOS level.
5. Measurement method for PSRR: VREFIN tied to VREFOUT, VA+ = VD+ = 5 V, a 150 mV
(zero-to-peak) (60 Hz) sinewave is imposed onto the +5 V DC supply voltage at VA+ and VD+ pins. The
“+” and “-” in pu t p ins o f b oth inpu t ch ann els are sh or te d to AGND. Then the CS5 463 is comma nded to
continuous conversion acquisition mode, and digital ou tput data is collected for the channel under test.
The (zero-to-peak) value of the digital sinusoidal output signal is determined, and this value is converted
into the (zero-to -peak) value of the sinusoidal vo ltage (measured in mV) tha t would need to be app lied
at the channel’s inp uts, in order to cause the same di gital sinusoidal output. This voltage is then defined
as Veq. PSRR is then (in dB)
:
6. When voltage level on PFMON is sagging, and LSD bit = 0, the voltage at which LSD is set to 1.
7. If the LSD bit has been set to 1 (because PFMON voltage fell below PMLO), this is the voltage level on
PFMON at which the LSD bit can be permanently reset back to 0.
Parameter Symbol Min Typ Max Unit
Analog Inputs (V oltage Channel)
Differential Input Range [(VIN+) - (VIN-)] VIN - 500 - mV
P-P
Tot al Harmonic Distortion THD 65 75 - dB
Crosstalk with Current Channel at Full Scale (50, 60 Hz) - -70 - dB
Input Capacitance All Gain Ranges IC - 0.2 - pF
Effective Input Impedance EII 2 - - M
Noise (Referred to Input) N
V
-140-µV
rms
Offset Drift (Without the High Pass Filter) OD - 16.0 - µV/°C
Gain Error (Note 3) GE - ±3.0 %
Temperature Channel
Temperature Accuracy T - ±5 - °C
Power Supplies
Power Supply Currents (Active State) I
A+
I
D+
(VA+ = VD+ = 5 V)
I
D+
(VA+ = 5 V, VD+ = 3.3 V)
PSCA
PSCD
PSCD
-
-
-
1.1
2.9
1.7
-
-
-
mA
mA
mA
Power Consumption Active State (VA+ = VD+ = 5 V)
(Note 4) Active State (VA+ = 5 V, VD+ = 3.3 V)
Stand-by State
Sleep State
PC -
-
-
-
21
11.6
8
10
29
17.5
-
-
mW
mW
mW
µW
Power Supply Rejection Ratio (50, 60 Hz)
(Note 5) Voltage Channel
Current Channel
PSRR 45
70
-
65
75
-
-
-
dB
dB
PFMON Low-voltage Trigger Threshold (Note 6) PMLO 2.3 2.45 - V
PFMON High-voltage Power-on Trip Point (Note 7) PMHI - 2.55 2.7 V
PSRR 20
150
V
eq
--------- -
log=