User guide

Elements of a Project
CS4953x4/CS4970x4 System Designer’s Guide
DS810UM6 Copyright 2013 Cirrus Logic, Inc 8-11
8.3.8 Power-up state Page
The Power-up state page is used to define the default DSP state at power-up. This page defines initial
modules (and their modes) to be loaded immediately after master boot.
Figure 8-9. DSP Condenser Wizard, Power-up state Page
Audio source — default audio source for power-up state
D
ecoder — default decoder for power-up state
M
atrix — default matrix for power-up state
V
irtualizer — default virtualizer for power-up state
P
ost processor — default post processor for power-up state
PPM modes — lists of supported PPM modules and their modes for power-up state
I
nput sample rate — default input sample rate for power-up state
S
tream sample rate — default stream sample rate for power-up state
O
utput sample rate — default output sample rate for power-up state
MC
LK factor — default MCLK factor for power-up state