Manual

CS4970x4 Data Sheet
32-bit High Definition Audio Decoder DSP Family
DS752F1 13
5.9 Switching Characteristics — Serial Control Port - SPI Slave Mode
Figure 3. Serial Control Port - SPI Slave Mode Timing
Parameter Symbol Min Typical Max Units
SCP_CLK frequency
1
,
2
1. The specification f
spisck
indicates the maximum speed of the hardware. The system designer should be aware that the actual
maximum speed of the communication port may be limited by the firmware application. Flow control using the SCP_
BSY pin
should be implemented to prevent overflow of the input data buffer. At boot the maximum speed is Fxtal/3.
2. When SCP1 is in SPI slave mode, very slow rise and fall times of the SCP_CLK edges may make the edges of the SCP_CLK
more susceptible to noise, resulting in non-smooth edges. Any glitch at the threshold levels of the SCP port input signals could
result in abnormal operation of the port. In systems that have noise coupling onto SCP_CLK, slow rise and fall times may cause
host communication problems. Increasing rise time makes host communication more reliable.
f
spisck
—— 25MHz
SCP_CS falling to SCP_CLK rising
2
t
spicss
24 — — ns
SCP_CLK low time
2
t
spickl
20 — — ns
SCP_CLK high time
2
t
spickh
20 — — ns
Setup time SCP_MOSI input
t
spidsu
5— —ns
Hold time SCP_MOSI input
t
spidh
5— —ns
SCP_CLK low to SCP_MISO output valid
2
t
spidov
—— 11ns
SCP_CLK falling to SCP_IRQ rising
2
t
spiirqh
— — 20 ns
SCP_CS rising to SCP_IRQ falling
2
t
spiirql
0— —ns
SCP_CLK low to SCP_CS rising
2
t
spicsh
24 — — ns
SCP_CS rising to SCP_MISO output high-Z
t
spicsdz
—20 —ns
SCP_CLK rising to SCP_BSY falling
2
t
spicbsyl
—3
*
DCLKP+20 — ns
SCP_BSY#
SCP_CS#
SCP_CLK
SCP_MOSI
SCP_MISO
SCP_IRQ#
0
12670
56
7
t
spicss
t
spickl
t
spickh
t
spidsu
t
spidh
t
spidov
A6 A5 A0 R/W MSB LSB
MSB LSB
t
spicsh
t
spibsyl
t
spiirql
t
spiirqh
f
spisck
t
spicsdz