Owner's manual

DS787PP9 12
5 Characteristics and Specifications
5 Characteristics and Specifications
Note: All data sheet minimum and maximum timing parameters are guaranteed over the rated voltage and temperature.
All data sheet typical parameters are measured under the following conditions: T = 25°C, VDD = 1.8 V, VDDIO =
VDDA = 3.3 V, GND = GNDIO = GNDA = 0 V.
5.1 Absolute Maximum Ratings
(GND = GNDIO = GNDA = 0V; all voltages with respect to 0V)
WARNING: Operation at or beyond these limits can result in permanent damage to the device. Normal operation is not
guaranteed at these extremes.
5.2 Recommended Operating Conditions
(GND = GNDIO = GNDA = 0V; all voltages with respect to 0V)
Note: It is recommended that the 3.3 V IO supply come up ahead of or simultaneously with the 1.8 V core supply.
5.3 Digital DC Characteristics
(Measurements performed under static conditions.)
Parameter Symbol Min Max Unit
DC power supplies:
Core supply
Analog supply
I/O supply
|VDDA–VDDIO|
VDD
VDDA
VDDIO
–0.3
–0.3
–0.3
2.0
3.6
3.6
0.3
V
V
V
V
Input pin current, any pin except supplies I
in
±10 mA
Input voltage on PLL_REF_RES V
filt
–0.3 3.6 V
Input voltage on digital I/O pins V
inio
–0.3 5.0 V
Analog Input Voltage V
in
AGND–0.7 VA+0.7 V
Storage temperature T
stg
–65 150 °C
Parameter Symbol Min Typ Max Unit
DC power supplies:
Core supply
Analog supply
I/O supply
|VDDA – VDDIO|
VDD
VDDA
VDDIO
1.71
3.13
3.13
1.8
3.3
3.3
0
1.89
3.46
3.46
V
V
V
V
Ambient operating temperature
Commercial—CQZ (147 MHz)
Automotive—DQZ (131 MHz)
Automotive—DQZ (113 MHz)
T
A
0
–40
–40
—+70
+85
+105
°C
Parameter Symbol Min Typ Max Unit
High-level input voltage V
IH
2.0 V
Low-level input voltage, except XTI V
IL
——0.8V
Low-level input voltage, XTI V
ILKXTI
——0.6V
Input Hysteresis V
hys
—0.4— V
High-level output voltage (I
O
= –2mA), except XTO V
OH
VDDIO*0.9 V
Low-level output voltage (I
O
= 2mA), except XTO V
OL
VDDIO*0.1 V
Input leakage XTI I
LXTI
—— 5 μA
Input leakage current (all digital pins with internal
pull-up resistors enabled)
I
LEAK
——70μA