Manual

38 DS792F2
CS43L22
Confidential Draft
3/4/10
7.3 Power Control 2 (Address 04h)
7.3.1 Headphone Power Control
Configures how the SPK/HP_SW pin, 6, controls the power for the headphone amplifier.
7.3.2 Speaker Power Control
Configures how the SPK/HP_SW pin, 6, controls the power for the speaker amplifier.
7.4 Clocking Control (Address 05h)
7.4.1 Auto-Detect
Configures the auto-detect circuitry for detecting the speed mode of the CS43L22 when operating as a
slave.
Notes:
1. The SPEED[1:0] bits are ignored and speed is determined by the MCLK/LRCK ratio.
2. When AUTO is disabled and the CS43L22 operates in Master Mode, the MCLKDIV2 bit is ignored.
3. Certain sample and MCLK frequencies require setting the SPEED[1:0] bits, the 32k_GROUP bit
(“32kHz Sample Rate Group” on page 39) and/or the VIDEOCLK bit (“27 MHz Video Clock” on
page 39) and RATIO[1:0] bits (“Internal MCLK/LRCK Ratio” on page 39). Low sample rates may also
affect dynamic range performance in the typical audio band. Refer to the referenced application for
more information.
76543210
PDN_HPB1 PDN_HPB0 PDN_HPA1 PDN_HPA0 PDN_SPKB1 PDN_SPKB0 PDN_SPKA1 PDN_SPKA0
PDN_HPx[1:0] Headphone Status
00
Headphone channel is ON when the SPK/HP_SW pin, 6, is LO.
Headphone channel is OFF when the SPK/HP_SW pin, 6, is HI.
01
Headphone channel is ON when the SPK/HP_SW pin, 6, is HI.
Headphone channel is OFF when the SPK/HP_SW pin, 6, is LO.
10 Headphone channel is always ON.
11 Headphone channel is always OFF.
PDN_SPKx[1:0] Speaker Status
00
Speaker channel is ON when the SPK/HP_SW pin, 6, is LO.
Speaker channel is OFF when the SPK/HP_SW pin, 6, is HI.
01
Speaker channel is ON when the SPK/HP_SW pin, 6, is HI.
Speaker channel is OFF when the SPK/HP_SW pin, 6, is LO.
10 Speaker channel is always ON.
11 Speaker channel is always OFF.
76543210
AUTO SPEED1 SPEED0 32k_GROUP VIDEOCLK RATIO1 RATIO0 MCLKDIV2
AUTO Auto-detection of Speed Mode
0 Disabled
1 Enabled
Application: “Serial Port Clocking” on page 29