Instruction Manual

DS723F1 23
CS43L21
4.2 Hardware Mode
A limited feature-set is available when the D/A powers up in Hardware Mode (see “Recommended Power-
Up Sequence” section on page 31) and may be controlled via stand-alone control pins. Table 2 shows a list
of functions/features, the default configuration and the associated stand-alone control available.
Hardware Mode Feature/Function Summary
Feature/Function Default Configuration Stand-Alone Control Note
Power Control Device
DACx
Powered Up
Powered Up
--
Auto-Detect
Enabled - -
Speed Mode Serial Port Slave
Serial Port Master
Auto-Detect Speed Mode
Single-Speed Mode
--
MCLK Divide
(Selectable) “MCLKDIV2” pin 2
see Section
4.4 on page 28
Serial Port Master / Slave Selection
(Selectable) “M/S” pin 29
see Section
4.4 on page 28
Interface Control DAC
(Selectable) “I²S/LJ” pin 3
see Section
4.5 on page 30
DAC Volume & Gain HP Gain
AOUTx Volume
Invert
Soft Ramp
Zero Cross
G = 0.6047
0 dB
Disabled
Enabled
Disabled
--
DAC De-Emphasis
(Selectable) “DEM” pin 4
see Section
on page 24
Signal Processing Engine (SPE) Mix
Beep
Tone Control
Peak Detect and Limiter
Disabled
Disabled
Disabled
Disabled
--
Data Selection
Data Input (PCM) to DAC - -
Channel Mix DAC
PCMA = L; PCMB = R - -
Charge Pump Frequency
(64xFs)/7 - -
Table 2. Hardware Mode Feature Summary