User Manual

38 DS671F2
CS4385
6.2.3 PCM/DSD Selection (DSD/PCM)
Default = 0
0 - PCM
1 - DSD
Function:
This function selects DSD or PCM Mode. The appropriate data and clocks should be present before
changing modes, or else MUTE should be selected.
6.2.4 DAC Pair Disable (DACx_DIS)
Default = 0
0 - DAC Pair x Enabled
1 - DAC Pair x Disabled
Function:
When the bit is set, the respective DAC channel pair (AOUTAx and AOUTBx) will remain in a reset state.
It is advised that chan ges to th ese bits be made wh ile the powe r-down (PDN) bit is ena bled to elimin ate
the possibility of audible artifacts.
Note: When the device is configured in TDM Mode by setting the DIF[3: 0] bit s t o 1100 (see Digital In-
terface Fo rm a t (D I F)), this function is not available and these bits must be set to 0 for proper operation.
6.2.5 Power Down (PDN)
Default = 1
0 - Disabled
1 - Enabled
Function:
The entire device will enter a low-power state when this function is enabled, and the contents of the control
registers are retained in this mode. The power-down bit defaults to ‘enabled’ on power-up and must be
disabled before normal operation in Control Port Mode can occur.
6.3 PCM Control (address 03h)
6.3.1 Digital Interface Format (DIF)
Default = 0000 - Format 0 (Left-Justified, up to 24-bit data)
Function:
These bits select the interface format for the serial audio input. The DSD/PCM
bit determines whether
PCM or DSD Mode is selected.
The required re lationship between the Left/Right clock, serial clock and serial data is defined by the Digital
Interface Format and the options are detailed in Figures 9 through 19.
Note: While in PCM Mode, the DIF bits should only be changed whe n the powe r-down (PDN) bit is set
to ensure proper switching from one mode to another.
76543210
DIF3 DIF2 DIF1 DIF0 Reserved Reserved FM1 F M0
00000011