Owner manual
Table Of Contents
- 1. Pin Descriptions
- 2. Characteristics and Specifications
- Recommended Operating Conditions
- Absolute Maximum Ratings
- DAC Analog Characteristics
- Combined Digital and On-Chip Analog Filter Characteristics
- Switching Specifications - Serial Audio Interface
- Digital Interface Characteristics
- Internal Power-On Reset Threshold Voltages
- DC Electrical Characteristics
- 2.1 Digital I/O Pin Characteristics
- 3. Typical Connection Diagram
- 4. Applications
- 5. Combined Digital and On-chip Analog Filter Response Plots
- Figure 10. Single-Speed Stopband Rejection
- Figure 11. Single-Speed Transition Band
- Figure 12. Single-Speed Transition Band (detail)
- Figure 13. Single-Speed Passband Ripple
- Figure 14. Double-Speed Stopband Rejection
- Figure 15. Double-Speed Transition Band
- Figure 16. Double-Speed Transition Band (detail)
- Figure 17. Double-Speed Passband Ripple
- Figure 18. Quad-Speed Stopband Rejection
- Figure 19. Quad-Speed Transition Band
- Figure 20. Quad-Speed Transition Band (detail)
- Figure 21. Quad-Speed Passband Ripple
- 6. Parameter Definitions
- 7. Package Information
- 8. Ordering Information
- 9. Revision History
DS895F2 5
CS4354
2. CHARACTERISTICS AND SPECIFICATIONS
RECOMMENDED OPERATING CONDITIONS
GND = 0 V; all voltages with respect to ground.(Note 1)
Notes: 1. Device functional operation is guaranteed within these limits. Functionality is not guaranteed or implied
outside of these limits. Operation outside of these limits may adversely affect device reliability.
ABSOLUTE MAXIMUM RATINGS
GND = 0 V; all voltages with respect to ground.
WARNING: Operation at or beyond these limits may result in permanent damage to the device. Normal operation
is not guaranteed at these extremes.
Notes: 2. The maximum over/under voltage is limited by the input current except on the power supply pin.
Parameters Symbol Min Typ Max Units
DC power supply Analog power
Interface power
VA
VL
4.75
1.4
5.0
1.8, 3.3, 5.0
5.25
5.25
V
V
Ambient operating temperature (power applied) -CSZ T
A
-40 - +85 °C
Parameters Symbol Min Max Units
DC power supply Low voltage analog power
Interface power
VA
VL
-0.3
-0.3
6.0
6.0
V
V
Input current, any pin except supplies I
in
-±10mA
Digital input voltage (Note 2) Digital interface V
IN-L
-0.3 VL+ 0.4 V
Ambient operating temperature (power applied) T
A
-55 +125 °C
Storage temperature T
stg
-65 +150 °C