Owner's manual

DS782F2 35
CS4349
8.7 Miscellaneous Control - Register 08h
8.7.1 Power Down (PDN) Bit 7
Function:
When set to 1, the entire device enters a low-power state, and the contents of the control registers is re-
tained. The power-down bit defaults to ‘0’ on power-up.
8.7.2 Freeze Controls (FREEZE) Bit 5
Function:
When set to 1, this function allows modifications to be made to the registers without the changes taking
effect until FREEZE is set back to 0. To make multiple changes in the Control Port registers take effect
simultaneously, enable the FREEZE bit, make all register changes, then disable the FREEZE bit.
When set to 0 (default), register changes take effect immediately.
8.7.3 Popguard Enable (POPG_EN) Bit 4
Function:
When set to 1, (default) the Device initiates a ramping function as outlined in Section 4.7 on page 22.
When set to 0, the outputs step to VQ upon release of PDN.
76543210
PDN Reserved FREEZE POPG_EN Reserved Reserved Reserved Reserved
00011100