Instruction Manual

DS882F1 89
CS42L73
6.11 XSP Master Mode Clocking Control (Address 0Dh)
Refer to XSP Master Mode Clocking relevant control bits “XSP SCLK Source Equals MCLK” on page 88.
6.11.1 XSP Master/Slave Mode
Applicable only if XSPDIF = 0b (I²S Format). Configures the XSP clock source (direction).
6.11.2 XSP Master Mode Clock Control Dividers
Applicable only if XSPDIF = 0b (I²S Format). Provides the appropriate divide ratios for all supported serial
port master mode clock timings.
6.12 ASP Control (Address 0Eh)
6.12.1 Tristate ASP Interface
Determines the state of the ASP drivers.
Note: Slave/Master Mode is determined by the ASP Master/Slave Mode bit described on page 90.
76543210
X_M/S Reserved X_MMCC5 X_MMCC4 X_MMCC3 X_MMCC2 X_MMCC1 X_MMCC0
X_M/S
Serial Port Clocks
0 Slave (Input)
1 Master (Output)
Application: Refer to section “Master and Slave Timing” on page 52.
X_MMCC[5:0] Master Mode Clock Control Settings
01 0101 Refer to section “Serial Port Sample Rates and Master Mode Settings” on page 53
Others
76543210
3ST_ASP Reserved ASPFS3 ASPFS2 ASPFS1 ASPFS0 A_SCK=MCK1 A_SCK=MCK0
3ST_ASP
ASP State
Slave Mode Master Mode
0 Serial port clocks are inputs and SDOUT is output Serial port clocks and SDOUT are outputs
1 Serial port clocks are inputs and SDOUT is HI-Z Serial port clocks and SDOUT are HI-Z
Application: Refer to section “High-impedance Mode” on page 52.