User Manual

74 DS851F2
CS42L56
6.23.3 ADC x Input Select
Selects the specified analog input signal into ADCx.
Note: Pseudo-differential inputs are not available when the PGA is bypassed. Use the AINx_REF bits
(Analog Input 1 x Reference Configuration and “Analog Input 1 x Reference Configuration” on page 74)
to properly configure the input channel.
6.24 HPF Control (Address 1Bh)
6.24.1 ADCx High-Pass Filter
Configures the internal high-pass filter after ADCx.
6.24.2 ADCx High-Pass Filter Freeze
Configures the high pass filter’s digital DC subtraction and/or calibration after ADCx.
6.24.3 HPF x Corner Frequency
Sets the corner frequency (-3 dB point) for the internal High-Pass Filter (HPF).
ADCxMUX[1:0] Selected Input to ADCx
00 PGAx - Use PGAxMUX bit (“PGA x Input Select” on page 77) to select an input channel.
01 AIN1x; PGA is bypassed.
10 AIN2x; PGA is bypassed.
11 AIN3x; PGA is bypassed.
76543210
HPFB HPFRZB HPFA HPFRZA HPFB_CF1 HPFB_CF0 HPFA_CF1 HPFA_CF0
HPFx High Pass Filter Status
0 Disabled
1 Enabled
HPFRZx High Pass Filter Digital Subtraction
0 Continuous DC Subtraction
1 Frozen DC Subtraction
HPFx_CF[1:0] HPF Corner Frequency Setting (Fs=48 kHz)
00 1.8 Hz
01 119 Hz
10 236 Hz
11 464 Hz