User Manual

DS899F1 67
CS4234
6.22 Interrupt Mask 1 (Address 1Fh)
6.22.1 Test Mode Error Interrupt Mask
Allows or prevents a Test Mode Error event from flagging the interrupt pin. A test mode error occurs when
an inadvertent I²C write places the device in test mode.
6.22.2 Serial Port Error Interrupt Mask
Allows or prevents a Serial Port Error event from flagging the interrupt pin. A serial port error occurs when
any of the following control port parameters are changed without first placing the device into power down
(power down is defined as all Power Down ADCx and Power Down DACx bits are set to 1):
• Serial Port Format: SP FORMAT[1:0]
• Speed Mode: SPEED MODE[1:0] (If the MCLK/F
S
ratio changes without the device being powered
down, it will flag this error as well as the Clocking Error.)
6.22.3 Clocking Error Interrupt Mask
Allows or prevents a Clocking Error event from flagging the interrupt pin. See Section 4.8 for details.
6.22.4 ADCx Overflow Interrupt Mask
Allows or prevents an ADCx Overflow event from flagging the interrupt pin.
76543210
MASK
TST MODE ERR
MASK
SP ERR
MASK
CLK ERR
Reserved MASK
ADC4 OVFL
MASK
ADC3 OVFL
MASK
ADC2 OVFL
MASK
ADC1 OVFL
MASK
TST MODE ERR
In the event of a Test Mode Error event, Interrupt Pin will:
0 Be Flagged
1 Not be flagged
MASK
SP ERR
In the event of a Serial Port Error event, Interrupt Pin will:
0 Be Flagged
1 Not be flagged
MASK
CLK ERR
In the event of a Clocking Error event, Interrupt Pin will:
0 Be Flagged
1 Not be flagged
MASK
ADCx OVFL
In the event of an ADCx Overflow event, Interrupt Pin will:
0 Be Flagged
1 Not be flagged