User Manual

DS899F1 64
CS4234
6.17.2 DAC1-4 Attenuation
Sets the mode of attenuation used for the DAC1-4 path.
Note: See Section 4.6.6 Volume Control for details regarding the attenuation modes.
6.17.3 Mute Low-latency Path
Mutes the low-latency path.
6.17.4 Mute DACx
Mutes the DACx signal.
6.18 DAC Control 4 (Address 15h)
6.18.1 VQ Ramp
Ramps common mode voltage “VQ” down to ground. This bit needs to be set before asserting reset pin.
6.18.2 TPS Mode 1 Gain Select
When “TPS MODE” bit in the "TPS Control" register is set to 1, this bit sets the gain of the signal through
the TPS path.
6.18.3 Power Down DACx
Powers down the DACx path.
DAC1-4 ATT Attenuation events happen:
0 On a soft ramp
1 Immediately
MUTE LL Low latency path is:
0 Not Muted
1 Muted
MUTE DACx DACx is:
0 Not Muted
1 Muted
76543210
VQ RAMP TPS GAIN Reserved PDN DAC5 PDN DAC4 PDN DAC3 PDN DAC2 PDN DAC1
VQ RAMP Effect:
0 VQ is set at nominal level (VA/2)
1 VQ is ramped from nominal level to ground.
TPS GAIN Effect:
0 Gain is 1
1Gain is 2
PDN DACx DACx is:
0 Powered Up
1 Powered Down