User Manual

DS880F4 21
CS4207
COMBINED DAC INTERPOLATION & ON-CHIP ANALOG FILTER RESPONSE
9. Measurement Bandwidth is from Stopband to 100 kHz.
DC ELECTRICAL CHARACTERISTICS
(AGND = 0 V; all voltages with respect to ground.)
10. The DC current draw represents the allowed current draw from the VCOM pin due to typical leakage
through electrolytic de-coupling capacitors.
11. Valid with the recommended capacitor values on VBIAS. Increasing the capacitance will also increase
the PSRR.
Parameter Min Typ Max Unit
Frequency Response 10 Hz to 20 kHz -0.01 - +0.01 dB
Passband to -0.01 dB corner
to -3 dB corner
0
0
-
-
21792
23952
Hz
Hz
StopBand - 26256 - Hz
StopBand Attenuation (Note 9) - 102 - dB
Total Group Delay - 0.196 - ms
Parameters Min Typ Max Units
VCOM Characteristics
Nominal Voltage
Output Impedance
DC Current Source/Sink (Note 10)
-
-
-
0.5•VA
23
-
-
-
10
V
k
A
VHP_FILT+ Characteristics
Nominal Voltage - 0.5•VA_HP - V
VHP_FILT- Characteristics
Nominal Voltage - -0.5•VA_HP - V
MIC BIAS Characteristics
Nominal Voltage VREFE = 000b
VREFE = 001b
VREFE = 010b
VREFE = 100b
DC Current Source (VA=5.0V)
(VA=3.3V)
-
-
-
-
-
-
Hi-Z
0.5•VA
GND
0.8•VA
5
3
-
-
-
-
-
-
V
V
V
V
mA
mA
Power Supply Rejection Ratio (PSRR) (Note 11) 1 kHz - 60 - dB