User Manual

CS4202
DS549PP2 29
4.11 Powerdown Control/Status Register (Index 26h)
EAPD External Amplifier Power Down. The EAPD pin follows this bit and is generally used to power
down external amplifiers. The EAPD bit is mutually exclusive with the SDSC bit in the Serial
Port Control Register ( Index 6Ah). The SDSC bit must be ‘clear’ before the EAPD bit may be
‘set’.
If the SDSC bit is ‘set’, EAPD is a read-only bit and always returns ‘0’.
PR6 Headphone Amplifier Powerdown. When ‘set’, the headphone amplifier is powered down.
PR5 Internal Clock Disable. When ‘set’, the internal master clock is disabled (BIT_CLK running).
The only way to recover from setting this bit is through a Cold Reset (driving the RESET# sig-
nal active).
PR4 AC-link Powerdown. When ‘set’, the AC-link is powered down (BIT_CLK off). The AC-link can
be restarted through a Warm Reset using the SYNC signal, or a Cold Reset using the RE-
SET# signal (primary audio codec only).
PR3 Analog Mixer Powe rdown ( Vref off). When ‘set’, the ana log mixer a nd vo lta ge refer ence are
powered down. When clearing this bit, the ANL, ADC, and DAC bits should be checked be-
fore writing any mixer registers.
PR2 Analog Mixer Powe rdown ( Vref on ). When ‘se t’, the ana log m i xer is po we re d do wn (the vo lt-
age reference is still active). When clearing this bit, the ANL bit should be checked before writ-
ing any mixer registers.
PR1 Front DACs Powerdown. When ‘set’, the DACs are powered down. When clearing this bit, the
DAC bit should be checked before sending any data to the DACs.
PR0 L/R ADCs and Input Mux Powerdown. When ‘set’, the ADCs and the ADC input muxes are
powered down. When clearing this bit, no valid data will be sent down the AC-link until the
ADC bit goes high.
REF Voltage Reference Ready Status. When ‘set’, the REF bit indicates the voltage reference is
at a nominal level.
ANL Analog Ready Status. When ‘set’, the analog output mixer, input multiplexer, and volume con-
trols are ready. When ‘clear’, no volume control registers should be written.
DAC Front DAC Ready Status. When ‘set’, the DACs are ready to receive data across the AC- link.
When ‘clear’, the DACs will not accept any valid data.
ADC L/R ADCs Ready Status . Whe n ‘se t’, the ADCs ar e re ad y to se nd data ac ro ss th e A C-lin k.
When ‘clear’, no data will be sent to the controller.
Default 000Fh. This value indicates all blocks are powered on. The lower four bits will change as the
CS4202 finishes an initialization and calibration sequence.
The PR[6:0] and the EAPD bits are po werd own contr ol for different sections of the CS4202 as well as external am-
plifiers. The REF, ANL, DAC, and ADC bits are read-on ly status bits which, when ‘set’, indicate that a particular sec-
tion of the CS4202 is ready. After the controller receives the Co dec Ready bit in input Slot 0, these status bits must
be checked before writing to any mixer registers. See Section 8, Power Management , for more information on the
powerdown functions.
D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
EAPD PR6 PR5 PR4 PR3 PR2 PR1 PR0 0000REFANLDACADC