Owner manual

40 DS963F4
CS35L32
7.16 Interrupt Mask 1
0OTE_
RLS
Overtemperature error protection release. Releases (removes) OTE-caused Speaker-Safe Mode if the OTE condition is no
longer present, which can be determined by reading OTE (see Section 7.19) twice.
0 (Default)
1
0  1  0 sequence
If the OTE condition is present, Speaker-Safe Mode is applied.
At the end of the sequence, if the OTE condition is no longer present, the Speaker-Safe Mode is
cleared, unless an amplifier short cause is still active.
Note: For these bits, if the condition that causes automatic protection becomes true again during the protection potential release sequence
(x_RLS: 0  1  0), protection is not removed, the related interrupt status bit is set again, and, if unmasked, a new interrupt is generated.
7.16 Interrupt Mask 1
Address 0x12
R/W
765 4 3 2 1 0
— M_ADSPCLK_ERR M_MCLK_ERR M_AMP_SHORT M_OTW M_OTE
Default 1 1 1 1 1 1 1 1
Interrupt mask register bits serve as a mask for the interrupt sources in the interrupt status registers. Interrupts are described in Section 4.2.
Bits Name Description
7:5 — Reserved
4 M_ADSPCLK_ERR Error masks
0 Unmasked
1 (Default) Masked
3 M_MCLK_ERR
2 M_AMP_SHORT AMP_SHORT mask
0 Unmasked
1 (Default) Masked
1M_OTWOTW mask
0 Unmasked
1 (Default) Masked
0M_OTEOTE mask
0 Unmasked
1 (Default) Masked
7.17 Interrupt Mask 2
Address 0x13
R/W
76 543210
M_VMON_OVFL M_IMON_OVFL M_VPMON_OVFL — M_PDN_DONE
Default1 1 1 1111 1
Interrupt mask register bits serve as a mask for the interrupt sources in the interrupt status registers. Interrupts are described in Section 4.2.
Bits Name Description
7 M_VMON_OVFL Overflow masks
0 Unmasked
1 (Default) Masked
6M_IMON_OVFL
5 M_VPMON_OVFL
4:1 — Reserved
0 M_PDN_DONE PDN_DONE mask
0 Unmasked
1 (Default) Masked
Bits Name Description