Manual
Table Of Contents
- 1. Pin Descriptions
- 2. Characteristics and Specifications
- 3. Typical Connection Diagram
- 4. Detailed Block Diagram
- 5. Applications
- 5.1 General Description
- 5.2 System Design
- 5.3 Power-Up and Power-Down
- 5.4 Volume & Muting Control Architecture
- 5.5 Volume Controls
- 5.6 Muting Controls
- 5.7 Zero-Crossing Detection
- 5.8 System Serial Control Configuration
- 5.9 I·C/SPI Serial Control Formats
- 6. CS3318 Register Quick Reference
- 7. CS3318 Register Descriptions
- 7.1 Ch 1-8 Volume - Addresses 01h - 08h
- 7.2 ¹dB Control - Address 09h
- 7.3 Mute Control - Address 0Ah
- 7.4 Device Configuration 1 - Address 0Bh (Bit 5)
- 7.5 Device Configuration 2 - Address 0Ch
- 7.6 Channel Power - Address 0Dh
- 7.7 Master Power - Address 0Eh
- 7.8 Freeze Control - Address 0Fh
- 7.9 Master1 Mask - Address 10h
- 7.10 Master1 Volume - Address 11h
- 7.11 Master1 Control - Address 12h
- 7.12 Master2 Mask - Address 13h
- 7.13 Master2 Volume - Address 14h
- 7.14 Master2 Control - Address 15h
- 7.15 Master3 Mask - Address 16h
- 7.16 Master3 Volume - Address 17h
- 7.17 Master3 Control - Address 18h
- 7.18 Group2 Chip Address 19h
- 7.19 Group1 Chip Address 1Ah
- 7.20 Individual Chip Address 1Bh
- 7.21 Chip ID - Address 1Ch
- 8. Parameter Definitions
- 9. Package Dimensions
- 10. Thermal Characteristics and Specifications
- 11. Ordering Information
- 12. Revision History
42 DS693F1
CS3318
8. PARAMETER DEFINITIONS
Dynamic Range
Full-scale (RMS) signal to broadband noise ratio. The broadband noise is measured over the specified
bandwidth with the input grounded. Expressed in decibels.
Total Harmonic Distortion + Noise
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.
Frequency Response
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response at
1 kHz. Units in decibels.
Interchannel Isolation
A measure of crosstalk between channels. Measured for each channel at the device’s output with a full-
scale signal applied to one channel adjacent to the channel under test, and no signal applied to all other
channels. Units in decibels.
Gain Error
The deviation from the nominal full-scale analog output for a full-scale digital input.
Gain Drift
The change in gain value with temperature. Units in ppm/°C.