User guide

DS702F1 33
CS3308
7.3 Mute Control - Address 0Ah
7.3.1 Mute Channel X (Bit 0 - 7)
Default = 0
Function:
Each bit controls the individual mute state of its respective channel. When set, the mute condition is
active. When cleared, the mute condition is released.
See “Muting Controls” on page 21 for more information about the muting behavior of the CS3308.
7.4 Device Configuration 1 - Address 0Bh (Bit 5)
7.4.1 Enable MUTE Input (Bit 5)
Default = 1
Function:
When set, the MUTE
input pin is enabled and will generate a mute condition when active. When
cleared, the MUTE
input pin is ignored and will not generate a mute condition.
7.4.2 MUTE Input Polarity (Bit 4)
Default = 0
Function:
This bit controls the active level of the MUTE
input pin.
When set, the mute condition is active when the MUTE
pin is high. When cleared, the mute condition
is active when the MUTE
pin is low.
76543210
MuteCh8 MuteCh7 MuteCh6 MuteCh5 MuteCh4 MuteCh3 MuteCh2 MuteCh1
76543210
Reserved Reserved EnMuteIn MutePolarity Ch8=7 Ch6=5 Ch4=3 Ch2=1