Owner manual

CS1630/31
DS954F3 35
6.14 Channel 1 Output Current (CH1CUR) – Address 41
CH1CUR sets the target output current for channel 1. The register value plus bit CH1CURMSB forms an un-
signed integer in the range of 0value511.
6.15 Configuration 10 (Config10) – Address 42
6.16 Channel 2 Output Current (CH2CUR)
– Address 43
CH2CUR sets the target output current for channel 2. The register value plus bit CH2CURMSB forms an un-
signed integer in the range of 0value511.
76543210
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
76543210
BUCK3 BUCK2 BUCK1 BUCK0 RE1_ZCD2 RE1_ZCD1 RE1_ZCD0 CH2CURMSB
Number Name Description
[7:4] BUCK[3:0]
Configures buck topology. The value is an unsigned integer in the range of
0value15.
0 = Normal buck configuration
1 = Tapped buck ratio of one which is equivalent to a normal buck
configuration
2-15 = Tapped buck configuration where the ratio is equal to N.
[3:1] RE1_ZCD[2:0]
Configures fixed time delay T
RE1ZCD(delay)
for zero-current detection (ZCD)
comparator to account for the delay on the rising edge of ZCD for channel 1.
The value is an unsigned integer in the range of 0value7. The delay is
defined by:
[0] CH2CURMSB
Most significant bit for the CH2CUR register (see "Channel 2 Output Current
(CH2CUR) – Address 43" on page 35).
76543210
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
T
RE1ZCD delay
RE1_ZCD= [2:0] 50ns