User Manual

CDB8421
4 DS641DB3
1.4 Clocking
Table 1 shows the available I/O configurations and their respective clock sources. When the
CS8416 is selected to master SCLK and LRCK (CS8421 input port set to slave), J7 should
be set to 8416. When the CS8421 input port is selected to master SCLK and LRCK (CS8416
set to slave), J7 may be set to 8416, OSC, or XTAL. When the CS8406 is selected to master
SCLK and LRCK (CS8421 output port set to slave), J13 should be set to OSC. When the
CS8421 output port is selected to master SCLK and LRCK (CS8406 set to slave), J13 should
be set to 8421. The board is shipped with a 24.576 MHz crystal/oscillator stuffed at Y1, Y2,
and Y3.
1.5 Clock and Data Headers
The CDB8421 includes headers for input (J8) and output (J11) port clocks and data. These
headers can enabled/disabled using S4. When not using these headers, SDIN should be
jumpered to SDOUT on both J8 and J11. The pin functions for headers J8 and J11 are shown
in Table 7.
The CDB8421 also includes a header for TDM operation (J16). Refer to the CS8421 data
sheet for possible TDM configurations [1]. This header can enabled/disabled using J14.
All headers operate at the VL supply, therefore any external circuit connected to these head-
ers should also operate at VL.
1.6 CPLD Board Setup
The CPLD (U2) controls all of the configuration for the CS8421, CS8416, and CS8406. The
CPLD decodes switches S1, S2, S3, and S4 and sets the appropriate mode of operation.
Switch S1 controls the master/slave and MCLK/LRCK ratio settings for the CS8421, CS8416,
and CS8406. The functions for S1[3:0] are detailed in Table 2.
CS8421 Input Port CS8421 Output Port CS8421 XTI/XTO Clock Source CS8406 OMCK Clock Source
Master Slave CS8416 RMCK Y3
Slave Master CS8416 RMCK, Y1, or Y2 CS8421 MCLK_OUT
Slave Slave CS8416 RMCK, Y1, or Y2 Y3
Table 1. Clock Sources
S1[3:0] CS8421 Input CS8421 Output
0000 Slave Slave
0001 Slave Master (Master Clock = 128*Fs)
0010 Slave Master (Master Clock = 256*Fs)
0011 Slave Master (Master Clock = 384*Fs)
0100 Slave Master (Master Clock = 512*Fs)
1000 Master (Master Clock = 128*Fs) Slave
1001 Master (Master Clock = 256*Fs) Slave
1010 Master (Master Clock = 384*Fs) Slave
1011 Master (Master Clock = 512*Fs) Slave
Table 2. Switch S1, Serial Input and Output Master/Slave and Speed Mode Settings