Owner's manual

CDB61884
20 DS485DB1
6.3 T1/J1 100 Ω Mode Setup
Table 6 shows the position of the different switches and jumpers used to set up the CDB61884 evaluation
board to operate in T1/J1 100 Ω Hardware, Serial Host and Parallel Host operational modes. Before se-
lecting host mode the switches in Table 6 in bold should be set to the position stated.
8. Set “LOW” to disable receiver Internal line impedance matching function. The external resistors for all
eight receivers must be changed to 12.5 Ω to properly match the input line impedance.
9. Selects T1/J1 100 Ω 0ft-133ft line length settings. These pins can be changed to select other T1/J1 100
Ω line length settings. Refer to the CS61884 Data Sheet for other settings.
Table 6. T1/J1 100 Ω Operational Mode Switch/Jumper Position
Switches/Jumpers Hardware Serial Host (Note 3) Parallel Host (Note 3)
S15 (MODE) HARDWARE SERIAL HOST PARALLEL HOST
S1 (0) LOOP FUNCTION NONE NONE
S2 (1) LOOP FUNCTION NONE NONE
S3 (2) LOOP FUNCTION NONE NONE
S4 (3) LOOP FUNCTION NONE NONE
S5 (4) LOOP FUNCTION NONE NONE
S6 (5) LOOP FUNCTION NONE NONE
S7 (6) LOOP FUNCTION NONE NONE
S8 (7) LOOP FUNCTION NONE NONE
S9 #1 (MOT_\INTL) OPEN (HIGH) HIGH MOTOROLA/INTEL
S9 #2 (MUX) LOW (Note 4) HIGH MUX/NON-MUX
S9 #3 (A4) LOW (Note 5) HIGH HIGH
S9 #4 (A3) LOW (Note 5) HIGH HIGH
S9 #5 (A2) LOW (Note 5) HIGH HIGH
S9 #6 (A1) LOW (Note 5) HIGH HIGH
S9 #7 (A0) LOW (Note 5) HIGH HIGH
S10 (JASEL) ANY POSITION OPEN OPEN
S11 (CBLSEL) NC or HIGH (Note 8) NC NC
S12(LEN2) LOW(Note9) OPEN OPEN
S13 (LEN 1) HIGH (Note 9) OPEN OPEN
S14 (LEN 0) HIGH (Note 9) OPEN OPEN
J13(VLOGIC)3V3V3V
J1 (MCLK) OSCILLATOR OSCILLATOR OSCILLATOR
J93 (CLKE) OPEN OPEN OPEN
J23 (TXOE) OPEN OPEN OPEN