Owner manual
Table Of Contents
- Features & Description
- Table of Contents
- List of Figures
- List of Tables
- 1. Initial Setup
- 2. Hardware Description
- 2.1 Block Diagram
- 2.2 Analog Hardware
- 2.3 Digital Hardware
- 2.4 Power Supplies
- 2.5 PCB Layout
- 3. Software Description
- 4. Bill Of Materials
- 5. Layer Plots
- 6. Schematics
- 7. Revision History
CDB5378
DS639DB4 7
1. INITIAL SETUP
1.1 Kit Contents
The CDB5378 evaluation kit includes:
• CDB5378 Evaluation Board
• USB Cable (A to B)
• Software Download Information Card
The following are required to operate CDB5378, and are not included:
• Bipolar Power Supply with Banana Jack Outputs (+/-12 V @ 100 mA)
• Banana Jack Cables (4x)
• PC Running Windows 2000 or XP with an Available USB Port
• Internet Access to Download the Evaluation Software
1.2 Hardware Setup
To set up the CDB5378 evaluation board:
• Set all jumpers and DIP switches to their default settings (see next sections).
• With power off, connect the CDB5378 power inputs to the power supply outputs.
VA- = -12 V
VA+ = +12 V
GND = 0 V
VD = +12 V
• Connect the USB cable between the CDB5378 USB connector and the PC USB port.
• Proceed to the Software Setup section to install the evaluation software and USB driver.