Owner manual
Table Of Contents
- Features & Description
- Table of Contents
- List of Figures
- List of Tables
- 1. Initial Setup
- 2. Hardware Description
- 2.1 Block Diagram
- 2.2 Analog Hardware
- 2.3 Digital Hardware
- 2.4 Power Supplies
- 2.5 PCB Layout
- 3. Software Description
- 4. Bill Of Materials
- 5. Layer Plots
- 6. Schematics
- 7. Revision History
CDB5378
DS639DB4 13
1.4 Self-testing CDB5378
Noise and distortion self-tests can be performed once hardware and software setup are complete.
First, initialize the CDB5378 evaluation system:
• Launch the evaluation software and apply power to CDB5378.
• Click ‘OK’ on the About panel to get to the Setup panel.
• On the Setup panel, select Open Target on the USB Port sub-panel.
• When connected, the Board Name and MCU code version will be displayed.
1.4.1 Noise test
Noise performance of the measurement channel can be tested as follows:
• Set the controls on the Setup panel to match the picture: