Manual

CDB5340
4 DS601DB1
* denotes default factory settings
CONNECTOR INPUT/OUTPUT SIGNAL PRESENT
VA/VD Input +3.3V to +5V power for the CS5340
VL Input +2.5V to +5V power for the CS5340
GND Input Ground connection from power supply
+5V Input + 5 Volt power
AINL Input Analog input left channel
AINR Input Analog input right channel
Optical Output Output Digital audio output
Coax Output Output Digital audio output
Table 1. System Connections
JUMPER/SWITCH PURPOSE POSITION FUNCTION SELECTED
J5 VA/VD Power Source ADJ
*+3.3V
+5V
Power from the Binding Post (J1)
Power from the +3.3V Regulator
Power from the +5V Supply
J6 VL Power Source ADJ
*+3.3V
+5V
Power from the Binding Post (J2)
Power from the +3.3V Regulator
Power from the +5V Supply
J11 Input/Output for
clocks/data
--
S1 Reset for the CDB5340 - -
S2 CDB5340 Configuration M1/M0 Open
*Closed
Hi
Low
SCLK/LRCK Open
*Closed
Header J11 is an input for clocks.
Header J11 is an output for clocks.
MCLK Open
*Closed
Header J11 is an input for MCLK.
Header J11 is an output for MCLK.
8406 Open
*Closed
CS8406 in Master mode
CS8406 in Slave mode
DIF Open
*Closed
Digital interface format set to I
2
S
Digital interface format set to
Left Justified
Table 2. CDB5340 Jumper and Switch Settings