User Manual

10 DS792DB1
CDB43L22
3.3 SPDIF In to Mono Speaker Out
The CS43L22’s mono differential PWM speaker output performance can be tested by loading the “SPDIF
In to Mono Speaker Out” quick setup file provided with the software package. The script configures the
digital clock and data signal routing on the board as shown in Figure 2.
Stereo output jacks J6 and J18 can be used to monitor filtered PWM output for measurement purposes. The
figure shows how a real speaker or a speaker model should attach to the binding posts during performace
tests. Please note how ONLY the tip from the stereo jacks is used to attach the mono differential channel
to the measurement device. Digital S/PDIF input can be provided on the optical (OPT2) or RCA (J68) jacks.
Refer to Section 4 on page 11 for details on software configuration.
Figure 3. SPDIF In to Mono Speaker Out
Table 3 shows the expected performance characteristics one should expect when using the CDB43L22
for SPDIF In to Mono Speaker Out measurements.
Table 3. SPDIF In to Mono Speaker Out Performance Plots
Plot Location
THD+N vs. Output Power- S/PDIF In to Speaker Out Figure 30 on page 30
Real
Speaker
Load
FPGACS43L22
CS8416
S/PDIF Rx
RX.RMCK
RX.LRCK
RX.SCLK
RX.SDOUT
S/PDIF
IN
Pin 4 – SPKOUTA+
Pin 6 – SPKOUTA+
Pin 7 – SPKOUTA-
Pin 9 – SPKOUTA-
Spkr A
Spkr B
J19
J6
J18
(MASTER)
(SLAVE)
4 Ω
15 µH
15 µH
Test Load
J15
+
-
OR
Measure -
ment
Device
+
-
MCLK
LRCK
SCLK
SDIN