Owner manual

DS900DB2 21
CDB4244
7. Silk-screen labels are placed near these connectors to indicate the phase reversal between the active
(“A”) and passive (“P”) configurations. See Section 5.1 on page 17 for more information.
8. When using an optional single-ended output filter, the single pin labelled “+” and “-” under the “A” and
“P” columns respectively is ignored. This connectivity is shown in Figure 15 on page 28 and Figure
16 on page 29.
9. These connectors are intended for use with one of the optional single-ended output filters and are not
used by default. Refer to Section 5 on page 17 for more information.
6.2 Jumper Pin Blocks
Notes:
10. See the CS4244 data sheet for performance differences between VA supply levels.
11. J63 and J64 must be closed during normal operation.
6.3 Test Points
The CDB4244 contains several convenient test points for analyzing signals to and from the CS4244. A
looped test point is available for each digital signal of the device’s control port and audio serial port, adjacent
to the respective external connection headers (J1 and J2, described in Table 3 on page 20). These test
points are connected directly to the appropriate CS4244 pins and can be used both with external control
(through the use of J1 and J2), or normal operation (J1 and J2 configured as described in Section 1.8 on
page 5).
Test points are available for analog signals as well. The three-pin headers described in Table 3 on page 20
serve as breakouts to allow access to the raw analog input signals, or filtered analog output signals. Fur-
thermore, two-pin headers (J41–J48) are available to observe the analog input and output pins of the
CS4244.
Note: Headers J41–J48 should not be shunted. They are test points that have been designed using head-
ers to simplify layout.
Label Ref. Designator Purpose Position Function Selected
+5V Select J62 Selects +5-V voltage source. POST*
USB
Voltage source is +5 V EXT binding post.
Voltage source is USB.
VA Select J61 Selects VA voltage source.
See Note 10.
+5V
+3.3V*
VA is +5 V.
VA is +3.3 V.
VA Current J63 VA supply current measure-
ment.
Open
Closed*
1-Ω resistor placed in series in supply path.
1-Ω resistor is shorted. See Note 11.
VL Current J64 VL supply current measure-
ment.
Open
Closed*
1-Ω resistor placed in series in supply path.
1-Ω resistor is shorted. See Note 11.
*Default factory setting
Table 4. Jumper Pin Blocks