Owner manual

AN298RC14 25

6.3 PCM Manager in DSP Composer

All configuration information described in Section 6.2 can be controlled in DSP Composer. Note that IO Buffer Channel

availability is device specific. The PCM Manager is part of the System block. To insert System block, drag in onto the

workspace. Once the System block is on the workspace the runtime and pre-kick controls for the PCM Manager can be

accessed by double-clicking the System block. When the System Block is first dragged onto the workspace the user is

prompted to select device and input mode as seen in Fig. 6-1. These settings can also be accessed by right-clicking the

System block and selecting Device Properties.

Figure 6-1. DSP Composer System Block Device Properties

The runtime controls are accessed by double-clicking the System Block as seen below in Fig. 6-2.

Figure 6-2. DSP Composer PCM Manager Runtime Controls

For the IO Buffer Channel Remap on the CS48520, see Fig. 6-3.

Note: This is different for each device.

Figure 6-3. DSP Composer IO Buffer Remap for cs48520