User`s guide

SEM2410
The following commands are issued by typing radio and then the subcommand followed by the
subcommand parameters if any.
Command Description
help
Displays command list
banner
Displays power on banner for the radio in the SEM
defaults
Resets the radio parameters to the factory shipped values
masterbw [
10..80]
(Master only)
Displays master to slave bandwidth in percentage
Sets master to slave bandwidth in 10 percent increments between 10
and 80 percent. Remainder of bandwidth is shared among slaves for
slave to master communication
Default = 50
maxslaves [
0..15]
(Master only)
Displays value currently in use
Sets the maximum number of slaves the master will allow to register.
Default = 15
network [
0..63]
Displays current SEM network number
Sets the network number for the SEM
Default = 0
power [
low|high]
Displays radio output setting: low = 10dBm; high=18dBm (Default)
Sets radio output power
show
Displays radio parameters that have been modified from factory
settings
radio
spid [
0..254]
Displays service provider ID
Sets service provider ID
Default = 0
help Displays list of sub-commands under the radio command.
banner Displays the power on banner of the radio inside the SEM.
defaults Replaces any modified parameters with the factory default values.
masterbw Sets the percentage of the total RF bandwidth to be allocated to the Master
transmissions. Ranges from 80 percent to 10 percent in 10 percent increments.
Default is 50 percent. The RF bandwidth not allocated to the Master transmissions
is shared among the slave SEMs for transmissions to the Master.
maxslaves Sets a limit to the number of slaves SEMS that a master SEM can have registered
simultaneously. The default is 15 but the parameter can range from 1 to 15. If
© 2000- 2005 Cirronet™ Inc 28 M-2410-0018 Rev C