User`s guide

SEM2410
SEM Security Commands
Command Description
access help
console [enable|disable]
ip [help
add <ipaddr>
delete <ipaddr>
disable
enable
show]
show
Displays command help screen
Enables/disables password requirement for direct
console communications.
Displays command help screen
Sets IP addresses (up to 10) from which telnet
sessions will be accepted
Deletes ipaddr from list of allowed telnet initiators
Turns off telnet initiator limitation
Turns on telnet initiator limitations
Displays telnet initiator limitations settings
Displays console and IP setting
ftpw Changes the password for FTP sessions
password <pwd> Changes the password for telnet/console sessions
access Group of commands that limit access to the SEM through the console port and telnet
sessions. Note that there is no command to enable or disable the telnet session
password. It is always enabled.
console enable sets the requirement that a password be entered when starting a
console connection. The password is set using the
password command. The default
setting is disabled.
console disable removes the password requirement.
ip enable sets limitations set on initiating a telnet session to the SEM. When
enabled, only network devices with IP addresses on the list of IP addresses added
can initiate a telnet session with the SEM. Up to 10 IP addresses can be added to the
list. The list is modified with the
add and delete subcommands. ip disable allows
telnet sessions to be initiated from any IP address (a password will still be required).
show will display the setting of the ip command and the list of IP addressed entered
when enabled.
ftpw This command changes the password required to initiate an FTP session with the
SEM. The default password is “Cirronet” (without quotes). It is not possible to
disable this password.
password This command changes the password required to initiate a telnet session with the
SEM and initiate a serial connection through the console port when enabled. The
default password is “Cirronet” (without quotes). It is not possible to disable the
password requirement for a telnet session, but it is possible to disable the password
requirement for the console connection.
© 2000- 2005 Cirronet™ Inc 25 M-2410-0018 Rev C