User`s guide

ManualsBrandsCirronet ManualsComputer equipmentSEM2410

Table Of Contents

SEM2410

SEM Command Set

The SEM supports a series of commands that allow for configuring the Ethernet interface as well

as the radio parameters of the on-board WIT2410. These commands can be entered during a

telnet session or by using the WinSEM24 utility when the

SEM> prompt is displayed. The

commands are grouped into System, Bridge, Security, Ethernet and Radio command sets. The

commands are summarized here with detailed explanations following.

System Commands

Command Description

help Displays command help screen

arp –a

-d <ipaddr>

-s <ipaddr> <eaddr>

Displays arp table

Deletes arp entry

Adds arp entry

default Sets SEM configuration to factory default settings

echo Toggles user screen echo mode

ip [

<ipaddr> <netmask>]

Displays current SEM IP address

Sets SEM IP address and optionally the netmask

ping <ipaddr> Pings TCP/IP host

reset

Resets the SEM activating changed configuration

parameters

route [ help

add <default> <gwaddr>

del <ipaddr>

list ]

Displays help screen for command

Adds IP address and netmask to route list

Deletes IP address from route list

Lists route IP addresses

save Stores current configuration to memory

sys help

mode

outmax

(Master only)

Displays sys help screen

Displays Master/Slave mode of the SEM

Sets maximum number of bytes Master SEM can

transmit per hop. Range is from 1 to 208

Default = 208

version Diplays SEM firmware version

help Displays a list of all the SEM commands. Most commands that require a parameter

also have a help mode that displays the help screen for that command.