User`s guide

Table Of Contents

SEM2410

System Settings

This dialog allows the user to change the Hostname, set the Default Route, enter DNS entries or change

the Outmax (upload/download ratio for the radio) setting. If the SEM2410 is to transmit data to devices

not on its subnet, a default router must be specified. To set the default routing address, enter it in the

Default Route field. Click on Apply to invoke changes, click on Cancel to discard.

System Ethernet Stats

This dialog displays statistics related to the transmission and reception of wired Ethernet data.

Radio Settings

This dialog identifies the radio and current operating mode. It also allows the user to configure radio

parameters for the Network, SPID, Master Bandwidth, Max Slaves, HopSet, Power, Sync and Retries.

Details on these settings are provided in the section on Radio Commands.