User`s guide

Table Of Contents

SEM2410

The power connector is a 2-pin DIN type connector. The provided AC adapter provides a 12 volt

power level to the SEM. The SEM2410 and SEM2410DX can accept DC voltages ranging

between 12VDC and 30VDC if alternative power supplies are to be used.

Status Indicators

The PWR indicator on the front panel indicates that power is applied to the SEM. The SEM does

not have a power switch. Power is applied and removed to the SEM by connecting and

disconnecting the power connector.

The Ethernet LEDs include LINK, TXD and RXD. The LINK LED lights when a valid Ethernet

connection is made. The SEM is set up to use a straight through cable to connect to a PC. If a

straight through cable is used to connect the SEM to other devices through a hub, the SEM must

be connected to the uplink port on the hub. TXD and RXD are indicators of Ethernet data

activity. They indicate the transmission and reception of data over the Ethernet connection. Note

that these LEDs can be active even when the SEM is not communicating with another SEM.

The RF indicators include LINK and XCVR OK. On a slave SEM, the RF Link LED indicates

the SEM has established a connection with the master SEM. When a slave SEM is powered on, it

will take a few seconds for this LED to turn on. On a master SEM the RF Link LED is on as long

as any one Slave is linked. When the XCVR OK LED is on, that indicates the remote radio is

operating properly.