User`s guide

HopNet RS-232 Serial ModBus Radio

Modem Command Summary

Serial Commands

sd[?|00..ff] Set Data Rate Divisor

sp[?|00..14] Set Protocol Mode

Network Commands

wb[?|0|1] Set Transceiver Mode

wd[?|0..3f] Set Default Handle

wn[?|00..3f] Set Hopping Pattern

wg[?|0|1] Enable Global Network Modes

wp[?|0|1] Set Transmit Power

wr? Read Receive Signal Strength (remote only)

wu[?|0|1] Set Point-to-Point Direct Mode

dx[?|0..ff] Set Range Optimization (remote only)

Protocol Commands

pe[?|0..9] Set Alternative Frequency Band

ph[?|00..fe] Set Hop Duration (base only)

pl? Get Maximum Data Length

pn[?|01..3e] Set Maximum Number of Remotes (base only)

pk[?|00..d4] Set Minimum Data Length

pr[?|00..ff] Set Packet Attempts Limit

pt[?|00..ff] Set Data Transmit Delay (remote only)

pv[?|0|1] Set Slot Assignment Mode (base only)

pw[?|00..34] Set Base Slot Size (base only)

px[?|0|1] Set ARQ Mode

Status Commands

zb[?|0|1] Banner Display Disable

zc[?|0..2] Set Escape Sequence Mode

zh? Read Factory Serial Number High Byte

zm? Read Factory Serial Number Middle Byte

zl? Read Factory Serial Number Low Byte

zp[?|0..4] Set Duty Cycle (base only)

zq[?|0|1] Enable Low Power Acquisition (remote only)

z> Exit Modem Control Mode

Memory Commands

m0 Recall Factory Defaults

m< Recall Memory

m> Store Memory

m! Display Modified Settings

Adapter Commands

QP[0|1|2] Protocol Mode

QD[value x 3ms] Maximum Transmit Delay

QW[0|1|2] Adapter Wiring Mode

QS[0|1..8] Serial Data Options