User`s guide

Set Transmit Power.............................................................................................................29
Read Receive Signal Strength Indicator (RSSI) .................................................................29
Set Point-to-Point Direct Mode............................................................................................29
Set Range Optimization ......................................................................................................30
Protocol Commands ................................................................................................................31
Set Alternative Frequency Band .........................................................................................32
Set Hop Duration.................................................................................................................32
Set Minimum Data Length...................................................................................................32
Get Maximum Data Length (read only) ...............................................................................32
Set Maximum Number of Remotes (base only) ..................................................................33
Set Packet Attempts Limit...................................................................................................33
Set Data Transmit Delay.....................................................................................................33
Set Slot Assignment Mode (base station only) ...................................................................33
Set Base Slot Size (base station only)................................................................................34
Set ARQ Mode....................................................................................................................34
Status Commands ...................................................................................................................35
Banner Display Disable.......................................................................................................35
Set Escape Sequence Mode...............................................................................................35
Read Factory Serial Number High, Middle and Low Bytes. ................................................36
Set Duty Cycle ....................................................................................................................36
Enable Low Power Acquisition Mode..................................................................................36
Memory Commands ................................................................................................................37
Recall Factory Defaults.......................................................................................................37
Recall Memory ....................................................................................................................37
Store Memory......................................................................................................................37
Modem Command Summary...................................................................................................38
Guidelines for Installation ........................................................................................................39
Guidelines for Placing the Repeater........................................................................................39
Typical HopNet Applications.......................................................................................................40
Introduction..............................................................................................................................40
Point to Multipoint ....................................................................................................................40
Troubleshooting ..........................................................................................................................41
Overview..................................................................................................................................41
Introduction .........................................................................................................................41
Transceiver Requirements..................................................................................................41
Common System Problems.....................................................................................................42
Guidelines for Reducing Interference ......................................................................................43
Introduction .........................................................................................................................43
Guidelines for Setting Up the Network................................................................................43
Guidelines for Selecting Your Site ......................................................................................43
Guidelines for Avoiding Terrain Obstructions ..........................................................................44
Customer Support....................................................................................................................45
Introduction .........................................................................................................................45
Technical Assistance ..........................................................................................................45
Factory Repairs...................................................................................................................45
Warranty .....................................................................................................................................46