User`s guide

HN-2010

HN-2010 Repeater

Introduction

The HopNet Repeater (HN-2010) provides extended range capability between two

HopNet networks. This repeater capability allows HopNet networks to be “daisy-

chained” in series to send and receive data from remote locations that would

otherwise be outside the coverage area of a single network.

If a remote unit is unable to communicate with the Base because of distance or

obstruction, you can install a repeater. Repeaters work by re-transmitting the data

from the outlying remote to the base and vice versa. The repeater will introduce a

small amount of transmission delay. However, as a dual modem repeater, the HN-

2010 does not halve the data throughput which is common in store -n- forward

repeaters.

Design Features

The HopNet Repeater consists of the following:

• Two modems. One for communicating with out-of-range units. The other re-

transmits to the base.

• A backup battery supply (with built-in charging circuitry)

All components of the repeater are located inside a rugged, NEMA 4X weatherproof,

aluminum enclosure. Connections into and out of the box have been kept to a

minimum to reduce the chances of industrial agents getting inside the unit. The

enclosure is weatherproof and will resist the normal grime associated with industrial

environments.