User`s manual

CR-SEB
Getting Started
The CR-SEB family of wireless Ethernet modems is easy to install and operate. In most instances, the
only installation steps will be setting IP addresses, configuring one CR-SEB as the master and connecting
the antenna, power and Ethernet cable. While the operation of the CR-SEB and CR-SEBX is the same,
the installation and connection is slightly different. Please refer to the appropriate section below for
connection and installation of your product.
Setting up a pair of CR-SEBs requires the following steps:
• Enter IP addresses into each CR-SEB
• Configure one CR-SEB as the Master
The default settings in the CR-SEBs are sufficient to allow connection to Ethernet networks and to have
the slave CR-SEB connect with the master. Other steps you may want to take include:
• Enter a default route IP address if data is to be sent off the CR-SEB’s subnetwork (See
Ethernet
Commands
)
• Enable one or more of the security features of the CR-SEB (See
Security Commands)
• Adjust the RF bandwidth allocation (See
Radio Commands)
• Filter out broadcast and multicast packets (See
Bridge Commands)
• Change the network number (
See Radio Commands)
Instructions on setting up the CR-SEBs are detailed in the
Configuring the CR-SEB section of this
manual. Details on the various operating modes and configurations can be found the
CR-SEB Operation
section.
 2000- 2004 Cirronet Inc 1 M-2410-0025 Rev A