User`s manual

CR-SEB
default Resets CR-SEB configuration parameters to factory default settings. This command does not
reset the radio parameters. Use the
radio default command to reset the radio parameters.
See the section on
Radio Commands for details.
echo Toggles the user screen mode to echo characters typed by the user. Default is on. If echo is
turned off, characters typed will not be displayed on the screen unless echoed by the
terminal program.
ip Sets the IP address of the CR-SEB. The default IP address is 0.0.0.0. When specified
netmask sets the netmask number. The default netmask is 255.255.255.0.
ping Sends inquiry packets to TCP/IP host specified in
<ipaddr> and displays the amount of
time that elapsed before a response was received. Continuously sends requests until a key is
pressed.
reset Resets the CR-SEB and loads saved parameters into active memory. Also causes the CR-
SEB to reinitialize which can take 30 seconds. If reset is issued before the save command,
the new parameters are lost and the last saved parameters are used.
route Displays and manipulates gateway IP addresses to route IP traffic off the subnet.
Default
sets the first gateway attempted.
save Saves changed parameters in non-volatile memory to be loaded on power up. Must be issued
before the reset command or cycling power to have changed parameters take effect. (An
exception is the
sys outmax command which becomes active immediately after it is
entered.)
sys mode displays whether CR-SEB is configured as a Master or Slave. Setting Master or Slave
mode is performed using the bridge command. Refer to the section
Bridge Commands for
details.
outmax controls how data is presented to the CR-SEB radio. This command should not be
used without advice from Cirronet Technical Support.
version Displays the CR-SEB firmware version.
 2000- 2004 Cirronet Inc 19 M-2410-0025 Rev A