User`s manual

CR-SEB
CR-SEB Command Set
The CR-SEB supports a series of commands that allow for configuring the Ethernet interface as well as
the radio parameters of the on-board WIT2410. These commands can be entered during a telnet session or
by using the WinSEM utility when the
SEM> prompt is displayed. The commands are grouped into
System, Bridge, Security, Ethernet and Radio command sets. The commands are summarized here with
detailed explanations following.
System Commands
Command Description
help Displays command help screen
arp –a
-d <ipaddr>
-s <ipaddr> <eaddr>
Displays arp table
Deletes arp entry
Adds arp entry
default Sets CR-SEB configuration to factory default settings
echo Toggles user screen echo mode
ip [
<ipaddr> <netmask>]
Displays current CR-SEB IP address
Sets CR-SEB IP address and optionally the netmask
ping <ipaddr> Pings TCP/IP host
reset
Resets the CR-SEB activating changed configuration
parameters
route [ help
add <default> <gwaddr>
<netmask>
del <ipaddr>
list ]
Displays help screen for command
Adds IP address and netmask to route list
Deletes IP address from route list
Lists route IP addresses
save Stores current configuration to memory
sys help
mode
outmax <1..208>
(Master only)
Displays sys help screen
Displays Master/Slave mode of the CR-SEB
Sets maximum number of bytes Master CR-SEB can
transmit per hop. Range is from 1 to 208
Default = 208
version Diplays CR-SEB firmware version
help Displays a list of all the CR-SEB commands. Most commands that require a parameter also
have a help mode that displays the help screen for that command.
arp Manipulates the address resolution procedure table. This command is provided primarily as
a debugging tool for setting up networks.
ipaddr is the device IP address and eaddr is the
physical Ethernet address of the device
 2000- 2004 Cirronet Inc 18 M-2410-0025 Rev A